FreeBSD Manual Pages
XHCI(4) Kernel Interfaces Manual XHCI(4) NAME xhci -- USB eXtensible Host Controller driver SYNOPSIS options USB_DEBUG device xhci DESCRIPTION The xhci driver provides support for the USB eXtensible Host Controller Interface, which allows use of USB 1.0, 2.0 and 3.0 devices on the same USB port. The XHCI controller supports USB connection speeds from 5.0Gbps and above when using USB 3.x compliant devices. HARDWARE The xhci driver supports XHCI compatible controllers having PCI class 12 (serial bus), subclass 3 (USB) and programming interface 48 (XHCI). SYSCTL VARIABLES The following variables are available as both sysctl(8) variables and loader(8) tunables: hw.usb.xhci.debug Set debug output level, where 0 is debugging disabled and larger values increase debug message verbosity. The default value is 0. hw.usb.xhci.dcepquirk Set to enable quirk for deconfiguration of endpoints. The de- fault value is 0. hw.usb.xhci.ctlquirk Set to submit full USB control request as one job, up to 64kBytes. Else the USB control request will be split into mul- tiple smaller requests. The default value is 1. hw.usb.xhci.streams Set to enable USB streams support. The default value is 0. hw.usb.xhci.route Set bitmap for switching EHCI ports to the XHCI controller. The default value is 0. hw.usb.xhci.polling Set to use a timer to poll the interrupt handler. The default value is 0. hw.usb.xhci.dma32 Set to only use 32-bit DMA for the XHCI controller. The de- fault value is 0. hw.usb.xhci.ctlstep Set to enable control endpoint status state stepping. The de- fault value is 0. SEE ALSO ehci(4), ohci(4), uhci(4) and usb(4) HISTORY The xhci device driver first appeared in FreeBSD 8.2. FreeBSD 14.3 October 21, 2022 XHCI(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | SYSCTL VARIABLES | SEE ALSO | HISTORY
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=xhci&sektion=4&manpath=FreeBSD+14.3-RELEASE+and+Ports>